超聲波清洗機的使用操作以及規程_
瀏覽： 發布日期：2019-08-27
超聲波清洗機的使用操作以及規程_濟南潔升超聲波清洗機
目 的：擬定B2200S型超聲波清潔器的標準操作程序 范 圍：適用于B2200S型超聲波清潔器的操作 責任人：質檢室全體人員 內 容：
1、運用過程：
目 的：擬定B2200S型超聲波清潔器的標準操作程序 范 圍：適用于B2200S型超聲波清潔器的操作 責任人：質檢室全體人員 內 容：
1.1、 在清潔器不帶電的狀況下，將清潔液參加清潔槽內。 1.2、將清潔器插頭刺進相對應的電源。
1、運用過程：
1.3. Press the ON switch and allow the cleaner to degas for 2-3 minutes.
1.1、 在清潔器不帶電的狀況下，將清潔液參加清潔槽內。 1.2、將清潔器插頭刺進相對應的電源。
1.4, according to the situation of dirt removal, usually clean 30 seconds ** 2 minutes, for items that are particularly difficult to clean, the cleaning time can be extended appropriately.
1.3、按下ON開關，答應清潔器作業2-3分鐘除氣。
1.5. Remove the cleaned items from the cleaning tank and rinse them under clear water. 1.6, dry and cleaned items, and oil as needed. 2, note · nbsp ^ fen ^
1.4、根據污垢去掉的狀況，通常清潔30秒**2分鐘，對于特別難清潔的物品，清潔時刻可適當延伸。
2.1, the cleaning machine should be used in an environment that is clean, boring and free of strong corrosive gases, and should prevent violent sensation. 2.2, the back of the generator should have a satisfactory cooling space.
1.5、將清潔過的物品從清潔槽中取出，放在清水下漂洗。 1.6、枯燥被清潔物品，并根據需要上油。 2、注意事項
2.3, to ensure that the machine has an excellent grounding to prevent personal injury. 2.4 When the cleaning machine is working, do not immerse your fingers in the cleaning solution.
2.1、清潔機應放在清潔、枯燥以及無強腐蝕氣體的環境中運用，并應防止劇烈轟動。 2.2、發生器背面應留有滿足的散熱空間。
2.5. It is forbidden to start up under no-load condition. The change of the liquid level bump will cause the change of the output power to be large. When cleaning the object, it is longer than finding the good working liquid level, so that the output power of the cleaner is large, and the cleaning liquid does not support the cleaning liquid. Start work and the liquid level must not be less than half of the groove depth. 2.6. The object to be cleaned shall not touch the bottom of the tank, and it is recommended to put the workpiece into the tooling basket for cleaning.
2.3、保證機器有杰出的接地，以防止人身傷害事故。 2.4、清潔機作業時，不要將手指浸入清潔液中。
2.7. The cleaning liquid can be contacted with the seller. The cleaning liquid should not be strong acid or alkaline, and there is no reliable safety measure.2.5、禁止空載狀態下開機。液位凹凸的改變會引起輸出功率巨細的改變，清潔物件時，要長超聲波清洗機價格于尋找**好的作業液位，使清潔器輸出功率**大，在清潔槽內無清潔液的狀況下，不答應開機作業，且液位不得低于槽深的一半。2.6、被清潔物不得和槽底觸摸，主張將工件放入工裝籃中清潔。
Under the conditions of application, solvents or flammable solutions that do not contain water cannot be used.
2.7、清潔液的選用可與銷售商聯系，清潔液不得呈強酸或強堿性，在沒有可靠的安全措
2.8. Under normal conditions, the cleaner will heat up for 10-15 minutes, and the cleaning machine will work in succession **
施條件下，不能運用不含水的溶劑或易燃溶液。
Beyond 8 hours.
2.8、在正常狀況下，清潔器接連作業10-15分鐘會升溫，清潔機接連作業時刻**好不要
2.9 If it is found that there is water leakage in the cleaning tank, it should be shut down and shut down, and the cleaning liquid should be emptied and contact the seller; 2.10, do not allow the private line to open the machine.
超越8小時。
2.11. When cleaning dexterous or valuable items, you should first test one item and then other
2.9、如發現清潔槽有漏水現象，應當即關機停用，并倒空清潔液后與銷售商聯系； 2.10、不答應私行拆開機器。
Items are cleaned.
2.11、當**次清潔精巧或貴重物品時，你應先將一件物品做一下試驗，隨后再將其他
2.12. If the cleaned items are mechanical parts, they must be cleaned one by one and oiled immediately after cleaning.
